Search This Blog

Thursday, July 24, 2014

Back to the Mine!

To me, that phrase, "Back to the mine!" evokes ideas of drudgery and hard, back-breaking work.  I suppose I indulged in a little drudgery this morning but it was far from back-breaking.  Mind numbing, perhaps, if I set out to do it all in one sitting, but not so much when broken down into manageable chunks.  Good thing this is a hobby and there are no deadlines!

Here is the mine in question, sitting on my portable workbench, at my dining room table:


BTW, the beautiful girl with the big hair in the picture at the back of my workbench is my wife, long before we knew each other.  In that picture she was doing her hair for some formal event.  Yes, I keep a picture of my wife on my workbench.

Anyway, I had set the mine aside for a long time, well over a year, I think.  The workbench had some serious dust on it, which I used to my advantage.  The next step in this model was/is the application of rafter tails.  Tiny little bits of wood that stick out under the eaves.  TINY.  But this work is made easier with a NWSL chopper to cut the little buggers all to the same length, and a piece of masking tape with guide lines drawn on it.  In order to keep the tape from pulling up the paint and rust from the roof panels, and possibly the panels themselves, I stuck the tape in the workbench dust to reduce the tackiness.

Speaking of tacky, if you're a Weird Al Yankovic fan, you should check out this music video.

Here's the tape in place and a few rafter tails applied:





I did a dozen this morning and it took about a half hour, including the set-up time for the chopper and tape.  I had to make a fresh jar of Titebond carpenter's glue since the old had gotten dry months ago.  The next dozen are cut and shouldn't take as long to apply.  I will cut and place the remaining tails on the FRONT of the building, but it is doubtful that I will do the back.  We'll see. 

It may be that life is too short to put rafter tails on the back of the Red Mountain Mine.